What is an AC Bypass Pulley?
An AC bypass pulley is a free spinning pulley used to replace the AC compressor on an automotive engine. When the AC compressor goes bad in a vehicle, a consumer often will choose to install an AC bypass pulley. ...Once installed the vehicle will no longer have air conditioning.
* Allows the use of your OEM size belt
* Replaces seized or defective A/C Compressor
* Bracket bolts in place of the removed A/C Compressor
* Correct only for models with factory installed air conditioning
1. Take the vehicle that is to have the AC bypass pulley installed to a local shop to have any remaining Freon removed from the system.
2. Lift the vehicle's hood and support it with the with the factory installed prop rod. Sketch out the approximate location of each pulley and how the belt wraps around those pulleys with the pen and paper.
3. Attach the belt tensioner tool into the corresponding fitting on the belt tensioner. Release the tension on the belt by rotating the belt tensioner tool. While keeping tension off the belt, carefully remove it from around each pulley and set it aside. Allow the tensioner to rest in its natural position and remove the belt tensioner tool.
4. Locate the two lines that connect into the AC compressor and remove them with the line wrench set. Follow the lines back to their other connecting point and remove them with the line wrench set.
5. Locate the mounting bolts for the AC compressor and loosen them with the socket and ratchet set. Support the AC compressor with one hand and remove the mounting bolts by hand. Set the old AC compressor aside.
6. Line up the AC Bypass Pulley mounting holes with the mounting holes on the engine that were originally used for the AC compressor. Begin installing the mounting bolts by hand and tighten them down with the socket and ratchet set.
7. Visually inspect the serpentine belt for cracks or wear, and replace as necessary. Carefully route the belt around the pulley system using the sketched routing diagram. The belt should rest loosely around all pulleys except the tensioner pulley.
8. Attach the belt tensioner tool to the belt tensioner. Rotate the belt tensioner by applying pressure to the belt tensioner tool. Slide the serpentine belt under the belt tensioner. Slowly release pressure on the tensioner tool until the belt tensioner sits on the belt and draws the belt tight around the pulley system. Remove the belt tensioner tool from the belt tensioner.
TIP;
when routing the serpentine belt always start with the harmonic balancer and work towards the top of the engine.
Warnings;
Never start an engine without the serpentine belt properly installed. All engine accessories are designed to rotate a certain way so the serpentine belt routing must be exactly the same as before it was removed.
Items you will need;
Pen and Paper, Belt tensioner tool, Line wrench set, Socket and ratchet set.
Chevy C/K Series Pickup Bypass Pulley
Legal; (our lawyers made us put this in) THIS PUBLICATION IS PROVIDED -AS IS- WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED. IN NO EVENT SHALL 1 AUTO SHOP LLC OR ANY OF ITS AFFILIATES BE LIABLE FOR ANY DAMAGES, OF ANY KIND, UNDER ANY THEORY OF LIABILITY, ARISING OUT OF USE OF THIS PUBLICATION. 1 AUTO SHOP LLC ASSUMES NO RESPONSIBILITY FOR ERRORS OR OMISSIONS IN THIS PUBLICATION OR DOCUMENTS REFERENCED BY OR LINKED HERETO.
You must login to post comments.